FS (USA,MD): Cusco Zero 2 Coilovers

Originally purchased these from another member a year ago. They spent a total of approximately 10-11 months on a car that has seen about 2000 road-only miles in that time frame. I should have replaced the tophats, but was in rush to get them on the car (limited time & access to good tools). Recently pulled them from the car to replace the tophats & ended up getting a great deal on another set. They handled very nice & have no evidence of leakage.

More detail...
1st off, they will need new/ or replacement tophats all around.
The adjustment marks on the rear are clearly visible, but the front plastic caps that show the dampening# were gone prior to me purchasing them. The rears have Cusco plates, but the rubber on the plate is gone. (Might be able to rebuild for cheaper than a pair of new because its just a reinforce rubber bushing)
To get the fronts on, I drilled out a pair of 04 sti tophats & they bolted right up. l gave the Cusco camber plates to a buddy to rebuild because the pillow ball was loose on one & missing a piece on the 2nd. The rebuild would have been more than a set of new, so I was just going to buy a set of new ones.
I know these should be blue, but I wire brushed & threw a coat of "rust resistant" paint on them. There is some rust on them, but its only surface, & doesn't effect the function of the coilover. The threading on all 4 is in good condition & fully functional. In the next few days I will pull the springs off & give them a better once-over to check for any kind of seepage. Tried to give as much detail as possible, but I am always open to questions. I don't post much here, but I'm the proud owner of a 2000 RSti with a Ver8.JDM swap. I have also purchased quite a few items from other members.

Asking $400 Shipped - $360 Local Pickup
Also willing to meet within 40 miles of 20771 or 21009.
Thanks for looking...