FS (USA,MA): V4 sti swap and extras

Brendan 978-833-7241 MASS

ENGINE: Price 2,000 (motor will include all of this)
JDM Version 4 STi motor COMPLETE EJ20k Engine and head. I believe I have engine and trans mounts as well and if I do I will include them.
Brand New timing belt kit was purchased (will include receipt) and was installed and I have the full gasket kit (over 1,000 in misc gaskets)
*intake manifold
*cylinder block
*sensors
*exhaust manifold
*fuel Rail
*injectors
*distributor
*throttle Body
*alternator
*ignition Wires
*pulleys
*oil Pan
*IHI VF24 Roller Bearing Turbo
*JDM RSTi TMIC
It's Semi closed deck which means the heads flow great. The crank is nitride from the factory for strength and durability and also cross drilled on the main bearing journals to allow for higher efficiency in oil flow to the big end bearings to prevent overheating and oil pressure loss at higher RPM. They make 280 whp (community general accepts these motors to actually put out 300+). That's just a little info about them in case you aren't too familiar with the motor..

TRANSMISSION: Price: 1,500
JDM Version 4 5MT 4.444 final drive ratio. when the car was still "intact" as far as it still being attached to the clip, The clutch was very stiff and seemed nice, went in all the gears perfectly.)

SUSPENSION:
BNIB Whiteline BSF12Z Adjustable sway bar Price: 150
BNIB Whiteline BSR20XZ22 Adjustable sway bar Price: 150
BNIB Kartboy F&R Endlinks Price: 150
BNIB TiC Suspension Bushings Price: 320
BNIB Whiteline W91380 Diff bushings Price: 75
BNIB Kartboy Pitchstop Price: 100

MISC:
99 RSTi Steering Wheel Price: 150
99 RSTi Gauge Cluster Price: 150

Again, Price for everything is 3,000. I'm pretty firm on it." 9788337241 Brendan