I hate to do this but life has made me need to sell a vehicle.
2005 Subaru Impreza RS with 59,xxx miles on it. Looking to get $8500 OBO. Engine and transmission run great and the interior is near mint condition (just needs cleaned up a bit). Body has some minor dents and dings. Car will come with any original parts that I still have. Stock RS wheels will be put back on for the sale. BRZ wheels are NOT included in this (even though pictured).
Clean Title in hand.
Current Mods:
EJ253 Block bored to 99.75mm
Wiseco 11:1 CR Pistons with STi wrist pin location (not 100% on CR, probably closer to 11.2-11.3:1 since the heads are decked and using STi head gasket)
STi Rods
STi Crank
ACL Main and Rod Bearings
PnP EJ251 Heads
Delta 2000 Regrinds
06 AVCS valve springs (slightly stiffer than 05 non-avcs springs)
8mm Intake manifold spacers
10mm Oil Pump
Oil Catch Can
Weapon Type R CAI
ACT Lightweight Flywheel (I think it is 14lbs)
OBX EL Heads with track pipe
Tsudo 2.5" catback exhaust
ST Coilovers
Whiteline 22mm Front Sway Bar
Whiteline 22-26mm Adjustable Rear Sway Bar
Whiteline Endlinks
Stoptech Slotted Rotors
Hawk Pads
Tuned by Motion Lab
Sound Clip:
2005 RS W OBX Header, Trackpipe, Tsudo 2.5" catback - YouTube
Build Thread: http://www.rs25.com/forums/f145/t113...e-s-05-rs.html
![]()
![]()
![]()
![]()
If you have any questions please ask.
2005 Subaru Impreza RS with 59,xxx miles on it. Looking to get $8500 OBO. Engine and transmission run great and the interior is near mint condition (just needs cleaned up a bit). Body has some minor dents and dings. Car will come with any original parts that I still have. Stock RS wheels will be put back on for the sale. BRZ wheels are NOT included in this (even though pictured).
Clean Title in hand.
Current Mods:
EJ253 Block bored to 99.75mm
Wiseco 11:1 CR Pistons with STi wrist pin location (not 100% on CR, probably closer to 11.2-11.3:1 since the heads are decked and using STi head gasket)
STi Rods
STi Crank
ACL Main and Rod Bearings
PnP EJ251 Heads
Delta 2000 Regrinds
06 AVCS valve springs (slightly stiffer than 05 non-avcs springs)
8mm Intake manifold spacers
10mm Oil Pump
Oil Catch Can
Weapon Type R CAI
ACT Lightweight Flywheel (I think it is 14lbs)
OBX EL Heads with track pipe
Tsudo 2.5" catback exhaust
ST Coilovers
Whiteline 22mm Front Sway Bar
Whiteline 22-26mm Adjustable Rear Sway Bar
Whiteline Endlinks
Stoptech Slotted Rotors
Hawk Pads
Tuned by Motion Lab
Sound Clip:
2005 RS W OBX Header, Trackpipe, Tsudo 2.5" catback - YouTube
Build Thread: http://www.rs25.com/forums/f145/t113...e-s-05-rs.html




If you have any questions please ask.